Plasma Cutter Amperage Chart

Plasma Cutter Amperage Chart – I have found that 20 amps is truly the lowest practical limit for a plasma cutter. The plasma cutter settings chart serves as a valuable tool, providing guidelines for amperage, gas pressure, cutting speed, and standoff distance. Start by using settings from a chart like what’s shown above as a starting point and begin testing from there. That amperage is good up to 1/8” of an inch.

Orifice hole size 1mm =.03937. The charts cover all the material thicknesses that can be cut with that system; Cut charts the following cut charts show the consumable parts, cutting speeds and the gas and torch settings required for each process. A plasma cutter with a lower amperage could cost less and it will consume less power.

Spectrum® plasma cutter comparison cutting capability rated sever power rated output (amps/duty cycle) input power v max amperage a weight with torch. Some plasma cutters use separate tips for the high and low end of their amperage ranges. The user manual should contain a chart or table.

The numbers shown in the cut charts. In finecut charts, the amperage setting for each thickness is included in the cut chart. There are many applications for plasma cutters.

The thickness of metal you will routinely. Explain which consumable set to use and at what amperage; After 1/8” you can typically add 10 amps for.

The hf torches can vary more, but simple, short test cuts can. When it comes to plasma cutter setup and technique, setting the correct amperage and using the right travel speed are key. There are several factors to consider when purchasing a plasma cutter.

Cut charts for everlast plasma 9 by hunterthehobbyist Plasma